Live Support
Live Support
Offline
Courses

**Remote Delivery of certain Instructor-led Open Enrollment and Site Specific courses is now available!**

CLICK HERE to see our upcoming schedule of Open Enrollment courses delivered remotely.
Contact your GE Representative or CLICK HERE to inquire about our remote delivery offerings for Site Specific Training.

Gas Turbine - LM6000: Gas Turbine - LM6000 Level 2 Cold Maintenance

Course Schedule

Location :  Houston, TX

Location
Start Date
Status
TXOctober 07,08,09,12,13,14,15 (2020)
TXNovember 30 (2020), December 01,02,03,04,07,08 (2020)
TXMarch 11,12,15,16,17,18,19 (2021)
TXJune 14,15,16,17,18,21,22 (2021)
TXAugust 09,10,11,12,13,16,17 (2021)
TXNovember 29,30 (2021), December 01,02,03,06,07 (2021)

Course Description

O-AER10304

lm6000 engine

Course Description

Instruction is designed so technical personnel responsible for the hands- on maintenance of the LM6000 will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

Duration

7 Days

Target Audience

Supervisors

Mechanical Maintenance

Prerequisites

Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

A basic understanding of your gas turbine or completion of the LM6000 Engine Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required.

Class Size

Maximum number of students:  8

Learning Objectives

This course will provide basic knowledge on the following:

  • Removal of variable inlet guide vane
  • Stage 0 blade replacement
  • Removal and re-installation of LP compressor
  • Replacement of #1 air / oil seal
  • LP compressor stage 1-3 blade replacement
  • LP compressor stage 0-3 vane replacement
  • Removal and re-installation of HP compressor upper case
  • HP compressor stage blade replacement
  • HP compressor stage vane replacement

Course Content

INTRODUCTION

  1. Instructor Background
  2. Participant Background
  3. Course Schedule

LESSON 1-2

  1. Course overview /content
  2. Training Manual review
  3. Removal Variable Inlet Guide Vane

LESSON  3

  1. Stage 0 Blades Replacement
  2. Removal Low Pressure Compressor Module
  3. Replacement No. 1 Air / Oil Seal

LESSON  4

  1. Low Pressure Compressor Stage 1-3 Blades Replacement
  2. Low Pressure Compressor Stage 0-3 Vanes Replacement
  3. Installation Low Pressure Compressor Module

LESSON  5

  1. Removal High Pressure Compressor Upper Case
  2. High Pressure Compressor Stage Blades Replacement

LESSON  6

  1. High Pressure Compressor Stage Vanes Replacement

LESSON  7

  1. Installation High Pressure Compressor Upper Case

 

Information Guide to Houston