Live Support
Live Support
Offline
Courses

Fleet360 Total Plant Solutions (Including Combined Cycle): Combined Cycle - Operations

Course Schedule

Location :  Houston, TX

Location
Start Date
Status
TXOctober 05,06,07,08,09 (2020)
TXOctober 11,12,13,14,15 (2020)

Course Description

O-CCP10205

Course Description

This course offers an understanding of the basic operations of GE Combine Cycle Plants and is designed for those persons with no or limited or basic knowledge of Combined Cycle Plants. The objective of this course is to give participants an understanding of basic Combined Cycle Power Plant operations as well as a fundamental knowledge of plant start-up, normal operations, shutdown and abnormal operations, with an emphasis on safe, efficient power plant operations.

This course is intended for personnel with limited or basic knowledge of GE Combined Cycle power plant operation.

Duration

5 Days

Target Audience

Delete those items not valid for this outline

Supervisors

Plant Operators

Mechanical Maintenance

Prerequisites

Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

Reasonable computer skills

Class Size

Maximum number of students: 15

Learning Objectives

This course will provide basic knowledge on the following:

  • Thermodynamic Review
  • Operating Philosophy
  • General Operator Responsibilities
  • Systems Review and Operation
  • Plant Start-up
  • Operations
  • Shutdown

 

Course Content

Lesson 1

  1. Introduction
  2. Thermodynamic Review
  3. Operating Philosophy
  4. General Operator Responsibilities
  5. Balance of Plant Systems Review and Operation

Lesson 2

  1. Gas Turbine Review and Operation
  2. HRSG Review and Operation
  3. Steam Turbine Review and Operation

Lesson 3

  1. Combined Cycle Startup
  1. Pre-Startup Requirements
  2. Gas Turbine Startup
  3. HRSG Startup
  4. Auto Drain Sequence
  5. Steam Turbine Startup

Lesson 4

  1. Combined Cycle Startup – Review
  2. Combined Cycle Normal Operation
  1. Off Peaking Operations
  2. GT Water Wash
  3. Routing Testing & Maintenance
  1. Combine Cycle Shutdown

Lesson 5

  1. Combined Cycle Startup - Review
  1. Load Rejection
  2. Trips
  3. Loss of Lube Oil
  4. Loss of Vacuum
  1. Review