Course Description

Instruction is designed so technical personnel responsible for the hands- on maintenance of the LM6000 will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

This course is intended for customers who want to expand their on-site maintenance capabilities to include internal repairs of the GE LM6000 Aeroderivative gas turbine.

Duration

7 Days

Target Audience

Supervisors

Mechanical Maintenance

Prerequisites

Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

A basic understanding of your gas turbine or completion of the LM6000 Engine Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required.

Class Size

Maximum number of students:  8

Learning Objectives

This course will provide basic knowledge on the following:

• Removal of LP turbine
• Removal of HP turbine
• Removal of stage 1 nozzle
• Removal of combustor
• Removal of #5 bearing and inner race
• Replacement of stage 2 HP turbine nozzle
• Re-installation of combustor, stage 1 nozzle, HP turbine and LP turbine

Course Content

INTRODUCTION

1. Instructor Background
2. Participant Background
3. Course Schedule

LESSON 1 - 2

1. Course overview /content 
2. Training Manual review 
3. Removal Low Pressure Turbine 

LESSON  3

1. Removal High Pressure Turbine Module 
2. Removal Stage 1 Nozzle Module 
3. Removal Combustor Module 

LESSON 4

1. Remove No.5 bearing inner race 
2. Remove No.5 bearing
3. Stage 2 High Pressure Turbine Nozzle Replacement

LESSON 5

1. Installation Combustor Module 
2. Installation Stage 1 Nozzle Module 

LESSON 6

1. Installation High Pressure Turbine Module

LESSON 7

1. Installation Low Pressure Turbine Module