Course Description

Instruction is designed so technical personnel responsible for the hands- on maintenance of the LM6000 will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

Duration

7 Days

Target Audience

Supervisors

Mechanical Maintenance

Prerequisites

Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

A basic understanding of your gas turbine or completion of the LM6000 Engine Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required.

Class Size

Maximum number of students:  8

Learning Objectives

This course will provide basic knowledge on the following:

• Removal of variable inlet guide vane
• Stage 0 blade replacement
• Removal and re-installation of LP compressor
• Replacement of #1 air / oil seal
• LP compressor stage 1-3 blade replacement
• LP compressor stage 0-3 vane replacement
• Removal and re-installation of HP compressor upper case
• HP compressor stage blade replacement
• HP compressor stage vane replacement

Course Content

INTRODUCTION

1. Instructor Background
2. Participant Background
3. Course Schedule

LESSON 1-2

1. Course overview /content
2. Training Manual review
3. Removal Variable Inlet Guide Vane

LESSON  3

1. Stage 0 Blades Replacement
2. Removal Low Pressure Compressor Module
3. Replacement No. 1 Air / Oil Seal

LESSON  4

1. Low Pressure Compressor Stage 1-3 Blades Replacement
2. Low Pressure Compressor Stage 0-3 Vanes Replacement
3. Installation Low Pressure Compressor Module

LESSON  5

1. Removal High Pressure Compressor Upper Case
2. High Pressure Compressor Stage Blades Replacement

LESSON  6

1. High Pressure Compressor Stage Vanes Replacement

LESSON  7

1. Installation High Pressure Compressor Upper Case