Live Support
Live Support
Online
Courses

**Remote Delivery of certain Instructor-led Open Enrollment and Site Specific courses is now available!**

CLICK HERE to see our upcoming schedule of Open Enrollment courses delivered remotely.
Contact your GE Representative or CLICK HERE to inquire about our remote delivery offerings for Site Specific Training.

Gas Turbine - LM2500: LM2500 Level 2 Cold Maintenance

Course Schedule

Location :  Houston, TX

Location
Start Date
Status
TXJuly 20,21,22,23,24 (2020)
TXAugust 10,11,12,13,14 (2020)
TXSeptember 21,22,23,24,25 (2020)
TXSeptember 28,29,30 (2020), October 01,02 (2020)
TXOctober 19,20,21,22,23 (2020)

Course Description

O-AER10104

Gas Turbine - LM2500 Level 2 Cold Maintenance 

LM2500

Course Description

Instruction is designed so technical personnel responsible for the hands- on maintenance of the LM2500 will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

This course is intended for customers who want to expand their on-site/shipboard maintenance capabilities to include internal repairs of the GE LM2500 Aeroderivative gas turbine.

Duration

5 Days

Target Audience

Supervisors

Mechanical Maintenance

Prerequisites

Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

A basic understanding of your gas turbine or completion of the LM2500 Engine Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required.

Class Size

Maximum number of students:  8

Learning Objectives

This course will provide basic knowledge on the following:

Use of OMM (Operation and Maintenance Manual)

Static balance program

Removal,   inspection   and   re-installation   of   internal   engine components  (radial  drive  shaft,  inlet  gear  box,  accessory  gear box, front frame, #3 bearing inner race, HP compressor case, HP compressor rotor blades)

Course Content

INTRODUCTION

  1. Instructor Background
  2. Participant Background
  3. Course Schedule

LESSON 1 & 2

Use of applicable Operation and Maintenance manuals

Removal, inspection and installation of internal engine components including:

Radial Drive shaft 

Inlet gearbox

Accessory Gearbox 

Front Frame

#3 bearing inner race

LESSON  3 – 4 - 5

Removal, inspection and installation of internal engine components including:

High Pressure Compressor Case

High Pressure Compressor rotor blades

Static balance program