Basic Gas turbine theory and operation and the knowledge required to ensure consistent, trouble-free performance from the engine and its associated equipment.

Instruction is designed so technical personnel responsible for the hands- on maintenance of the LM6000 will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

LM2500+ SAC/DLE Level 2 Maintenance (Cold Section)

nstruction is designed so technical personnel responsible for the hands- on maintenance of the LM2500+ will benefit most from this training. Scope of training focuses on selected Level 2 procedures identified in the applicable Operation and Maintenance manual.

A basic understanding of your gas turbine or completion of the LM2500+ Familiarization course is highly recommended, as well as a reasonable level of mechanical skill and use of hand tools is required. Instruction is given in English; therefore, a reasonable ability to read and understand spoken English is required.

• Picture ID is required. No visitors will be allowed to enter the training facility without a picture ID - NO EXCEPTIONS. Please carry a picture ID at all times while on any GE premises.
• The appropriate dress for this course is casual.
• Please note that CTEC is a place of business - no tank tops or shirts with inappropriate verbage or signs.
• All students taking maintenance training courses are asked to bring safety glasses (Z87 standard) and steel-toed shoes. Safety glasses will be worn when performing shop maintenance tasks. CTEC does have 1 pair of loaner shoes in the most popular sizes and disposable saftey glasses.
• Failure to have proper Personal Protective Equipment may result in student not being able to participate in hand-on portions of course."

The duration of this course is 5 days

Agenda

Day 1-2	Use of applicable Operation and Maintenance manuals
	Removal, inspection and installation of internal engine components including:
	Radial Drive shaft
	Inlet gearbox
	Accessory Gearbox
	Front Frame
	#3 bearing inner race

Day 3-5	Removal, inspection and installation of internal engine components including:
	High Pressure Compressor Case
	High Pressure Compressor rotor blades
	Static balance program

There are no additional recommendations for this course.

This course provides training on the essential elements of the Mk VI turbine control system. The course will include instruction on the hardware and software components of the Mk VI control system and its interface system (HMI). Alarm troubleshooting and LVDT calibration will be central topics of the program. Additionally, practical exercises on Mk VI equipment will reinforce the daily lecture material.